An intelligent opto-splitter that brings Ethernet-type features to plain DMX networks.

9115 Repeater Front Oblique

An increasingly important part of DMX data distribution systems, the Repeater Pro's support for RDM (Remote Device Management) allows the Repeater Pro to act as an RDM Controller, or a bidirectional RDM splitter.

In venues where a console is moved frequently, Hub Mode allows the Repeater Pro to sense which port is receiving DMX, the automatically route the signal to the remaining ports—eliminating the need for patch bays.

The Repeater Pro also allows for easy prioritization between two consoles, or HTP-merge two sources with one source able to roam—ideal for incorporating remote focus units.

  • Silent, fanless operation
  • 8 outputs
  • E1.20 RDM and  E1.11 DMX512A compliant
  • Three modes: RDM, Merge, and Hub
  • RDM discovery and end device management from the front panel
  • RDM can be disabled on a port-by-port basis to accommodate older equipment
  • Merge two controllers without any additional gear
  • Automatically switch a console between locations by simply unplugging and replugging the console
  • Units running in different modes can be chained together
  • Fully configurable from the front display
  • DMX output speed and signal loss behavior are user-selectable, including hold forever
  • Monitor incoming DMX signal levels in real time
  • DMX Console sends a channel level to all ports, for an independent DMX signal check on end devices
  • Self-resetting over-voltage protection on all ports
  • Ships with rack ears
  • 100-240VAC, 50/60 Hz wide-range power input
  • 0.08A maximum power consumption
  • Operating Conditions: 14°F to 104°F (-10°C to +40°C), 10-90% relative humidity, non-condensing
  • 2000V opto-isolation between DMX ports
  • 250V fault protection on DMX ports
  • USITT DMX512 –1990 ANSI E1.11 DMX512-A R2013
  • E1.20 RDM R2010—Remote Device Management
  • ETL
  • CE
  • RoHS 2011/65/EU
  • 5.2 lb (2.4 kg)
  • 17"W x 1.7"H x 7"D in (432mm x 43mm x 178mm)




DMX Repeater Pro, 8-way, Rear XLR5, Fully Isolated


DMX Repeater Pro, 8-way, Rear Terminal, Fully Isolated


DMX Repeater Pro, 8-way, Front XLR5, Fully Isolated


DMX Repeater Pro, 8-way, Rear RJ45 Ethercon, Fully Isolated


DMX Repeater Pro, 8-way, Front RJ45 Ethercon, Fully Isolated



Wall mount kit


Truss mount kit


Data Sheet



.DWG    .PDF